Installation Guide




8. Reinstall the enclosure’s cover, if removed in step 1.

WARNING: Only connect the Controller Board to 12V. Over voltage can damage the board.

To install a standalone Controller Board with 24V locking hardware:
If you purchased the Controller Board separately and are using 24V locking hardware, we
recommend using the LifeSafety Power E1 enclosure, FPO75 power supply (or FPV4 power supply),
B100 secondary power supply, and C4 power control module.

1. Follow all LifeSafety Power instructions for installing the FPO75 (or FPV4), B100, and C4 in the
enclosure.
2. Mount the Controller Board using the provided back plate.
3. Connect the B100 secondary supply to the Controller Board.
IMPORTANT: Verify that the jumper on the B100 is set to 12V.
4. Mount the enclosure as detailed above.

12/24V Smart Hub ACU Configuration



Version 1.5
© Openpath 2019
Page 5
