Installation Guide



To install a standalone Controller Board with 12V locking hardware:

If you purchased the Controller Board separately and are using 12V locking hardware, we

recommend using the FPV4-E1 power supply/enclosure.



1. Follow all LifeSafety Power instructions for installing the power supply in the enclosure.

2. Mount the Controller Board using the provided back plate.

3. Connect the power supply to the Controller Board.

IMPORTANT: Verify that the jumper on the FPV4 is set to 12V.

4. Mount the enclosure as detailed above.



12V Smart Hub ACU Configuration



 



Version 1.5

©

Openpath 2019

Page 6

