User manual

RIGE TECHNOLOGY CO., LIMITED
- 5 -
This product can be operated suspended or as a stand-alone system.
Should your lighting effect show any signs of damage, do not install the device! In this case, have your
lighting effect repaired by your specialized dealer. It does not accept responsibility or liability for damage to
property or personal injury resulting from an improperly installation!
As a stand-alone system the device must be installed vertically on an absolute planar, firm, fireproof, shock-
and vibration-free surface. The installation of this lighting effect must be carried out by trained and
professional staff! The installation of this lighting must only be carried out with the appropriate materials!
The suspended installation of this lighting effect necessitates a suitable suspension system! The lighting
effect must never be fixed swinging freely in the room. No individuals should linger underneath the lighting
effect during suspended installation!
It is a must to install this device with a second independent fixture. Such second fixture must guarantee in
the event of failure of the main fixture that no assembly parts will fall down. Use the fixture on the
undersurface only.
The light effect unit must be attached via two certified hooks and omega bracket to a tie-bar system. Use
the screw threads on the undersurface only.
It must be ensured that an expert inspects the mechanical and safety-relevant installation prior to the initial
operation and following major modifications, prior to the renewed operation. It must be ensured that an
expert inspects the mechanical and safety-relevant installation at least once a year. It must be ensured that
an expert inspects the mechanical installation and the installation of relevance to safety within the
framework of an acceptance test at least every four years.
The installation fixture must be as such that it can withstand for a period of 60 minutes 10 times the load
capacity without harmful deformation.
It is prohibited for any individual to unnecessarily stay or pass beneath the installation during any type of
assembly work.
The light effect unit must be secured by a safety arrester cable if fly-mounted. The cable must withstand 12
times the weight of the light effect unit. Use arrester cables equipped with quick closing links. The dropping
distance must not exceed 20 cm. Defect arrester cables or arrester cables that have already been exposed
to stress must not be used.
6. Operation
ATTENTION:
RISK OF HEALTH!
6
.1 Controls
Link all DMX devices with a DMX-512 controller by using a standard, 3-pin DMX cable. Connect the output
of the first device with the input of the second device and the output of the second device with the input of
the third device and so on.
Connect the mains plug to an outlet.
Operating the product for the first time may generate smoke and odor; this is not a defect. Avoid