User manual

RIGE TECHNOLOGY CO., LIMITED
- 9 -
7. Lamps
ATTENTION:
DANGER OF LIFE! RISK OF BURNS!
RISK OF FIRE!
During operation, the lamps will reach temperatures of up to 200°C. Touching the lamps may cause serious
burns! Objects coming into contact with the lamps during and shortly after operation may catch fire!
Disconnect the product from mains prior to installing or before changing a lamp! Allow a lamp to cool for
approx. 15 minutes before exchanging it!
Never touch a lamp with bare hands! If damaged or deformed, a lamp must be exchanged!
When exchanging the lamp be sure to use suitable lamps only. Lamps with greater performance generate
excessive heat for the product; risk of fire! Damage resulting from the use of an unsuitable lamp is exempt
from warranty!
Replace a lamp by unscrewing the fixing screws A, B and C. Then you open the housing. Remove the lamp
by unscrew the two ends of the bulb. Install a lamp by putting it into the socket and then properly fasten the
screws at its two ends. Do not use any force - this could cause serious damage to the socket as well as the
lamp! Close the compartment and tighten the screws. Adjust the lamp position by turning screws X, Y and
Z.
8. Fuse
ATTENTION:
DANGER OF LIFE!
Disconnect the product from the mains prior before changing a fuse.
Only replace the fuse by a fuse of same type and rating! An incorrect fuse could damage or destruct the
lighting effect.
Replace a fuse by levering the fuse holder cover with an appropriate screwdriver. Remove the old fuse and
place the fuse inside the holder. Replace the fuse holder and insert it.
9. Cle
aning
ATTENTION:
DANGER OF LIFE! RISK OF FIRE!
RISK OF SHORT CIRCUIT!
The product must be freed regularly from dust, other deposits and contamination as this may reduce the
protective insulation, which may lead to a fatal electric shock!
Before cleaning, always disconnect the product from mains!
This product should be cleaned with a moist cloth only; never use aggressive cleaning agents, solvents or
benzene for cleaning.