User Guide

ManualsBrandsRightline Gear ManualsAutomotiveRightline Gear 110750 Full-Size Short Truck Bed Tent 5.5'

1-Open the tailgate. Place the tent in your truck bed with

the mesh window side facing up. Slip the tent over the tail-

gate and run the tailgate strap underneath.

3-Loosely attach the C straps to the bottom outside lip of

the truck bed (Fig 3).

4-Open the door of the tent. Tilt the tailgate up and thread

the (2) orange straps (Fig 4) through the tailgate gap (the

space between the tailgate and the truck bed) (Fig 5).

Fig 1 Fig 2

5-Release the tailgate down. Pull up on the orange straps

to make sure each clip’s swivel base (Fig 6) stops against

the underside of the tailgate. If the clips pull up through

the tailgate gap, re-thread the orange straps through the

gap and fasten the clips to any points below the truck’s

bumper (Fig 7).

Set Up The Truck Tent

2-Pull the tent forward so that it covers the entire truck bed

(Fig 1). The front corners of the tent have split seams that

go over the front corners of the bed (Fig 2).

Fig 3

Fig 10

Fig 11

Fig 12

Fig 4 Fig 5

Fig 6

Fig 7

Fig 8

7-Attach the A and B straps to the bottom outside lip of the

truck bed (Fig 3) and tighten the A, B, and C straps. Make

sure the inner ap seams remain xed along the top outer

edges of the bed rails (Fig 8 and Fig 9).

6-Tighten the orange straps so the inner ap seams run

along the top outer edges of the bed rails (Fig 8 and Fig

9).

Fig 9

Inner Flap Seam

Tailgate

Side Flap

Truck Tents 110710, 110730, 110750, 110760,

110761, 110765, 110766, 110770

CAUTION: IF THE INNER FLAP SEAMS ARE NOT

EVEN WITH THE TOP OF THE BED RAILS, THE TENT

WILL NOT FIT THE TRUCK PROPERLY. DO NOT

OVER-TIGHTEN THE A, B, AND C STRAPS WHICH

WILL PULL THE INNER FLAP SEAMS BELOW THE TOP

OF THE BEDRAILS.

www.rightlinegear.com/setup.html

Set Up

Video:

CODE

CAUTION: DO NOT USE EXCESSIVE FORCE WHEN

TIGHTENING THE STRAPS.

Tailgate

Gap

Inner Flap Seam

Swivel

Base

8-Tighten the tailgate strap (Fig 10). Place the tailgate

side aps behind the bumper (on most trucks) (Fig 11). Run

the D straps over the A straps and attach them to the bot-

tom outside lip of the truck bed (Fig 12).

Summary of content (2 pages)

PAGE 1
5-Release the tailgate down. Pull up on the orange straps to make sure each clip’s swivel base (Fig 6) stops against the underside of the tailgate. If the clips pull up through the tailgate gap, re-thread the orange straps through the gap and fasten the clips to any points below the truck’s bumper (Fig 7). Truck Tents Set Up Video: QR CODE 110710, 110730, 110750, 110760, 110761, 110765, 110766, 110770 www.rightlinegear.com/setup.
PAGE 2
9-Run all (3) tent poles through their matching color pole sleeves (Fig 13). The (2) front poles are marked with orange tape and the rear pole is marked with gray tape (Fig 13 and Fig 14). The gray-marked pole should run under the (2) orange-marked poles (Fig 14). Orange Marking Pole Sleeve Orange Tape Fig 13 Fig 18 Orange-Marked Pole GrayMarked Pole Orange-Marked Pole Fig 14 Fig 19 3-Tie the (3) strings at the rear edge of the rainfly to the tent poles (Fig 20).