User Manual

Directions For: Saddlebag Car Clips
Add the Saddlebag Car Clips (Fig 1) to the side straps of
the Rightline Gear Cargo Saddlebag to attach the carrier
to vehicles WITHOUT a roof rack (Fig 2).
1- Place the Cargo Saddlebag top side up. Extend one of
the long side straps out. Make sure the strap is not twisted
(Fig 3 and Fig 4).
2-Remove the male buckle from the strap. Make sure the
other parts are positioned as shown (Fig 5).
3-Add the Saddlebag Car Clip and the male buckle onto
the strap (Fig 6). Make sure the strap goes through the
correct side of the buckle (Fig 6 Close-Up)
Fig 1 Fig 2
The correct attachment of this product is critical and
beyond the control of Rightline Gear. The safe use
and long life of this product depends entirely on
your good judgment and following these directions.
Fig 4
Fig 3
Male
Buckle
Pad
Tri-glide
Strap End
Strap
Male
Buckle
Male
Buckle
Fig 7
Fig 6
4-Run the strap back through the buckle, the Saddlebag
Car Clip, the pad, and the tri-glide. (Fig 7).
5-Repeat steps 1-4 for the second long side strap.
Male
Buckle
Pad
Tri-glide
Strap End
Strap
Pad
Pad
Tri-glide
Tri-glide
Strap
Strap
Strap End
Strap End
Grooves
Saddlebag
Car Clip
Saddlebag
Car Clip
Fig 5
Fig 6 Close-Up
Male
Buckle
Saddlebag
Car Clip
Top Side

Summary of content (2 pages)