Product Manual

1-Lay the neoprene window sleeve on a at surface with
the buckles on the underside (Fig 1).
2-Slide the (2) soft top side windows into the large pock-
ets (Fig 2).
5-Pull the rear window bar ush with the bottom of the
sleeve (Fig 8).
7-Buckle the (2) inside straps around the neoprene sleeve
and pull them tight (Fig 10).
8-Buckle the (2) outside straps around the neoprene sleeve
and pull them tight (Fig 10).
Place The Windows Inside The Neoprene Sleeve
The correct attachment of this product is critical and
beyond the control of Rightline Gear. The safe use
and long life of this product depends entirely on
your good judgment and following these directions.
Fig 6
6-Roll up the neoprene sleeve, applying pressure where
the windows most resist (Fig 9).
Fig 7
3-Place the rear window (with the rear window bar still
attached) on top of the neoprene pockets holding the (2)
side windows (Fig 6). Make sure the inner side of the win-
dow is facing up.
4-Cover the rear window with the sleeve’s top ap (Fig 7).
Fig 1
Fig 2
Inside
Straps
Fig 8
9-Unzip the opening at the end of the bag.
11-Zip up the opening at the end of the bag.
10-Slide the neoprene sleeve into the Storage Bag (Fig
11).
Fig 11
Fig 3
Fig 9
Fig 10
Outside
Straps
JK-The windows’ door side plastic retainer clips should
be ush with the bottom of the pockets (Fig 3).
Fig 4
Curved
Side
TJ-The windows’ curved side should be toward the bot-
tom of the pockets (Fig 4). The window’s body side plastic
retainer clips should be ush with the sleeve’s center
stitching (Fig 4).
YJ & CJ-The windows’ door side plastic retainer clips
should be ush with the bottom of the pockets (Fig 5).
Fig 5
Make sure the inner sides of the windows are facing up.
Retainer
Clips
Soft Top Window Storage Bag 100J78-B
Fits: Wrangler JK (2-door & 4-door), TJ, LJ, YJ, CJ

Summary of content (2 pages)