Owners manual

2018 JEEP

WRANGLER JL

BUMPER MOUNT

INSTALLATION INSTRUCTIONS

*THIS MOUNT FITS THE FOLLOWING LIGHTS:

(1) 20” E-Series PRO

(1) 20” SR-Series PRO

(1) 20” RDS-Series PRO

(1) 20” Adapt

NOTE: Part #’s: 41662, 41663, 41664

Bumper Mounts will use this instruction sheet.

* LIGHTS SOLD SEPARATELY

IMPORTANT

THANK YOU FOR PURCHASING RIGID PRODUCTS FOR YOUR VEHICLE.

Please read through all of these Instructions and tips before proceeding with the installation.

We do our best to provide a simple installation process for all applications however

a professional installation is always recommended.

Always disconnect any power sources connected to your vehicle

before servicing fuses or electrical systems.

PAGE 1
INSTALLATION INSTRUCTIONS 2018 JEEP® WRANGLER JL® BUMPER MOUNT NOTE: Part #’s: 41662, 41663, 41664 Bumper Mounts will use this instruction sheet. * LIGHTS SOLD SEPARATELY *THIS MOUNT FITS THE FOLLOWING LIGHTS: (1) 20” E-Series PRO®, (1) 20” SR-Series PRO®, (1) 20” RDS-Series PRO®, (1) 20” Adapt® IMPORTANT THANK YOU FOR PURCHASING RIGID PRODUCTS FOR YOUR VEHICLE. Please read through all of these Instructions and tips before proceeding with the installation.
PAGE 2
STEP 1 FIGURE 1 Begin installation by removing (3) factory Torx bolts from top of bumper as shown . See Figure 1 STEP 2 FIGURE 2 Install light bar mount bracket with the previously removed bolts as shown in Figure 2, and install lamp as directed in lamp instructions. Your installation is now complete! See Figure 2 Wiring: Wire your lights according to the instructions included with the light. Take care to avoid any heat sources and sharp or abrasive surfaces. Your installation is now complete.
PAGE 3
PAGE 4