User`s guide

RIGOL Chapter 3 Remote Control

3-2 DG1000Z User’s Guide

Remote Control via USB

1. Connect the device

Connect the USB DEVICE interface at the rear panel of DG1062Z with your PC

using a USB cable.

2. Install the USB driver

This generator is a USB-TMC device. Assuming that your PC has already been

installed with Ultra Sigma, after you connect the generator to the PC and turn

both on for the first time (the generator is automatically configured to USB

interface), the New Hardware Wizard as shown in the figure below is displayed

on the PC. Please install the “USB Test and Measurement Device (IVI)” driver

following the directions in the wizard. The steps are as follows.