User Guide

RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DG10× 2 Series
3-2
Output from Single Channel
Example 1: Output a Sine Waveform
How to generate a Sine Waveform with 20 kHz frequency, 2.5 VPP Amplitude, 0 VDC
Offset and 45° phase.
The operation steps:
1. Set the Frequency.
(1) Press Sine  Freq/Period  Freq which will display in reverse color.
(2) Enter “20” from the keypad and choose the unit “kHz”. The Frequency is set to be
20 kHz.
2. Set the Amplitude.
(1) Press Ampl/HiLev  Ampl which will display in reverse color.
(2) Enter “2.5” from the keypad and choose the unit “VPP”. The Amplitude is set to be
2.5VPP.
3. Set the Offset.
(1) Press Offset/LoLev  Offset which will display in reverse color.
(2) Enter “0” from the keypad and choose the unit “VDC”, The Offset is set to be 0 VDC.
4. Set the Initial Phase.
(1) Press Phase which will display in reverse color.
(2) Enter “45” from the keypad and choose the unit “°”. The phase is set to be 45°.
After finishing the above settings, press View, the output of the Generator is shown as
in the following figure.
Figure 3-1
Sine Waveform Output