Instructions
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DG1000Z Series Overview
- Document Overview
- Chapter 1 Quick Start
- Chapter 2 Front Panel Operations
- To Output Basic Waveform
- To Select Output Channel
- To Select Basic Waveform
- To Set Frequency/Period
- To Set Amplitude/High Level
- To Set Offset/Low Level
- To Set Start Phase
- Align Phase
- To Set Duty Cycle (Square)
- To Set Symmetry (Ramp)
- To Set Pulse Width/Duty Cycle (Pulse)
- To Set Leading/Trailing Edge Time (Pulse)
- To Enable Output
- Example: To Output Sine Waveform
- To Output Arbitrary Waveform
- To Output Harmonic
- Modulation
- Sweep
- Burst
- Counter
- Store and Recall
- Utility and System Settings
- To Install the Option
- To Lock the Keyboard
- To Output Basic Waveform
- Chapter 3 Remote Control
- Chapter 4 Troubleshooting
- Chapter 5 Specifications
- Chapter 6 Appendix
- Index
RIGOL Chapter 3 Remote Control
3-2 DG1000Z User’s Guide
Remote Control via USB
1. Connect the device
Connect the USB DEVICE interface at the rear panel of DG1062Z with your PC
using a USB cable.
2. Install the USB driver
This generator is a USB-TMC device. Assuming that your PC has already been
installed with Ultra Sigma, after you connect the generator to the PC and turn
both on for the first time (the generator is automatically configured to USB
interface), the New Hardware Wizard as shown in the figure below is displayed
on the PC. Please install the “USB Test and Measurement Device (IVI)” driver
following the directions in the wizard. The steps are as follows.
1
2
3
4