Specifications

RIGOL
Quick Guide for DG2000
5
Device Connection
Power Connection
Connect the power socket and AC supply with power cord attached
to the instrument. Turn on the power switch at the rear panel to
power on the generator, then press the power key on the front panel
to start the instrument immediately.
If start abnormally, please check according to the following steps:
1． Check if the power cord is normally connected and the power
switch on the rear panel has been turned on.
2． Check if the fuse is intact, or esle please replace it.
3． If the instrument still cannot be started, contact RIGOL for
help.
USB Connection
USB Host: This port is used to transfer data when external USB
device connects to the generator regarded as a “Host” device. For
example, connect a USB flash device for data storage.
USB Device: This port is used to transfer data when external USB
device connects to the generator regarded as a “Slave” device. For
example, connect with PC for remote control.
BNC Connection
Interfaces need to be connected by BNC Cable include: [Sync],
[Output] on the front panel and [10MHz In], [10MHz Out],
[Modulation In], [Ext Trig/FSK/Burst] on the rear panel.
Insert BNC cable to the connector vertically, and rotate clockwise to
lock it.