Manualshelf

Instructions

ManualsBrandsRigol ManualsFunction GeneratorsRigol DG2072 Mains-powered 0.000001 Hz - 70 MHz Sinus, Rectangle, Noise, Pulse, Triangle, Arbitrary
21222324252627282930
RIGOL Chapter 1 Quick Guide
1-10 DG2000 User Guide
3) FSK
When ASK, FSK, or PSK of CH1 is enabled and external modulation source is
selected, this connector receives an external modulation signal whose
polarity can be set by users. Its input impedance is 1000 Ω. For details,
refer to descriptions in "Modulation".
4) Trig In
When Sweep or Burst of CH1 is enabled and external trigger source is
selected, this connector receives an external trigger signal whose polarity
can be set by users.
5) Trig Out
When Burst of CH1 is enabled, and the internal/manual trigger source is
selected, this connector outputs a trigger signal with specified edge type.
3. [CH2/Sync/Ext Mod/Trig/FSK]
BNC female connector, with 50 Ω nominal impedance. Its function is determined
by the current working mode of CH2.
1) Sync
When the output of CH2 is enabled, this connector outputs the
corresponding sync signal that matches the current configuration of CH2.
For detailed information about the characteristics of the sync signals that
correspond to various output signals, refer to the descriptions in "Sync
Setting".
2) Ext Mod
When AM, FM, PM or PWM of CH2 is enabled and external modulation
source is selected, this connector receives an external modulation signal. Its
input impedance is 1000 Ω. For details, refer to descriptions in
"Modulation".
3) FSK
When ASK, FSK, or PSK of CH2 is enabled and external modulation source is
selected, this connector receives an external modulation signal whose
polarity can be set by users. Its input impedance is 1000 Ω. For details,
refer to descriptions in "Modulation".
4) Trig In
When Sweep or Burst of CH2 is enabled and external trigger source is
selected, this connector receives an external trigger signal whose polarity
can be set by users.
5) Trig Out
When Burst of CH2 is enabled, and the internal/manual trigger source is
selected, this connector outputs a trigger signal with specified edge type.
4. USB DEVICE
It is used to connect the generator to a computer which can control the
generator remotely by using PC software or by programming.
5. AC Power Cord Connector
The rated AC power source supported by the signal generator is (100-127 V,