Instructions

Chapter 2 Command System RIGOL
DG2000 Programming Guide 2-27
*TRG
Syntax
*TRG
Description
Triggers a sweep or a burst.
Remarks
 You can only trigger the sweep or burst via the remote interface when the sweep or burst function is
currently enabled and the trigger source is set to manual (use the
[:SOURce[<n>]]:SWEep:TRIGger:SOURce or [:SOURce[<n>]]:BURSt:TRIGger:SOURce command).
 You can also send the
[:SOURce[<n>]]:SWEep:TRIGger[:IMMediate] or
[:SOURce[<n>]]:BURSt:TRIGger[:IMMediate] command to trigger a sweep or a burst when the
sweep or burst function is currently enabled and the trigger source is set to manual.
*WAI
Syntax
*WAI
Description
Executes any other command via the interface after all the pending operations are completed.
Remarks
This command is only applicable to the triggered sweep mode or triggered burst mode, and is used to
ensure synchronization.