User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-80
According to the different choices of the point and the separator, the format can have
various forms.
(1) as point, press Separator On , the example is as follows:
Figure 2-92 Set Format
(2) as point, press Separator On , the example is as follows:
Figure 2-93 Set Format
(3) as point, press Separator No , the example is as follows:
Figure 2-94 Set Format
(4) as point, press Separator No , the example is as follows:
Figure 2-95 Set Format
(5) as point, press Separator Space , the example is as follows: