User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-86
Test
Press Utility Test/Cal , to enter the following menu.
Figure 2-99 The Test/Cal function Menu
Figure 2-100 Table 2-50 The Menu Explanations of Test Setting
Function
Menu
Settings
Explanation
Self -Test
Perform System Self-Test
Cal Info
Show the information for Calibration
times and other related ones
Secure
Code
Input the code for Secure calibration
Secure
On
Off
Turn On Secure Setting, disables the
calibration by anyone
Turn Off Secure Setting, enables the
calibration by anyone
Input
Secure Code