User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
3-2
Example 1: To Generate a Sine Wave
How to generate a Sine Waveform with 20kHz frequency, 25mVpp Amplitude and 0
Vdc Offset.
Steps:
1. Set the Frequency.
(1) Press Sine Freq and choose Frequency which will display in reverse
white color.
(2) Input “20” from the keypad and choose the unit “kHz”. The Frequency is set
to be 20 kHz.
2. Set the Amplitude.
(1) Press Ampl to choose the Ampl selection which will display in reverse
color.
(2) Enter “25” from the keypad and choose the unit “mVpp”. The Amplitude is set
to be 10mVpp.
3. Set the Offset.
(1) Press Offset to choose the Offset selection which will display in reverse
color.
(2) Enter “0” from the keypad and choose the unit “Vdc” to set the Offset 0Vdc.
When the Frequency, Amplitude and Offset are set, the waveform generated is
shown in figure 3-1.
Figure 3-1 The Sine Waveform