User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
4-1
Chapter 4 Prompt messages & troubleshooting
Prompting Message
Common Prompt Message
Need Help? Press and hold down any key.
Prompt Message 1. While using the instrument, uses can get help by using the
method above.
Settings are restored from last power-down.
Prompt Message 2. This is to inform the user that all the settings have been restored
and the user can operate the instrument normally.
Selected interface is USB, no USB device detected!
Prompt Message 3. When the instrument is powered, it detects that the current I/O
is USB, and informs the user that no new USB device is detected.
No Changes
When the waveform parameter is being altered, if the user cancels the operation, the
message will prompt.
Selected arb is ExpRise / ExpFall / NegRamp / Sinc / Cardiac.
This is to inform the user about the selected arbitrary waveform type. To change it,
press Sel Wform .
Please Wait…
It takes time to save or recall data, and this message is to tell the user to wait.
First, set the allover waveform parameters.
To inform the user, set the general waveform parameter first. Once finished, set the
parameters for other points.
Edit the existing waveform parameters.
Perform the waveform edit operation, and inform the user that operation can be
taken to edit the current waveform parameter.
The selected arbitrary waveform is Volatile.
Inform the user that the selected waveform is Volatile.
Restore all instrument settings to factory defaults?
If user wants to reset the instrument to the default setting, the system will prompt
this message, to confirm the operation, in case of accidental mistake.