User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-11
Figure 2-10 Table 2-3 The Menu Explanations of Ramp Waveform
Function
Menu
Settings
Explanation
Freq/
Period
Set the signal frequency or period;
the current parameter will switch at
a second press.
Ampl/
High Level
Set the signal Amplitude or High
Level; the current parameter will
switch at a second press.
Offset/
Low Level
Set the signal Offset or Low Level;
the current parameter will switch at
a second press.
Symmetry
Set the Symmetry for Ramp
Waveform.
Term Explanation:
Symmetry: The percentage that the Rising Period takes up the whole Period.
Input Range: 0~100%.