User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-19
To Set Arbitrary Signals
Press Arb button to call the Arb operation. The Arb waveform parameters are set by
using the Arb operation menu.
The Arb signal consists of two types: the system built-in waveform and the
user-definable waveform. The parameters for Arb waveforms are: Frequency/ Period,
Amplitude/ High Level and Offset/ Low Level. See figure 2-18. The parameter value in
the waveform display window is the same with that of in the parameter display
window. In the soft key menu, select Amplitude, and the corresponding value in the
waveform display window will be displayed in shadow, and then users can edit its
value.
Figure 2-18 The Arb Parameter Display Interface