User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-37
Press Mod Type FSK , to enter the following interface.
Figure 2-43 Table 2-24 The Menu Explanations of the FSK Parameters
Function
Menu
Settings
Explanation
FSK Rate
Set the frequency at which the output
frequency shifts between the carrier
frequency and the Hop frequency
(Internal Modulation Only):
2mHz~100MHz
Type
FSK
Frequency Shift Keying Modulation
Hop Freq
Set the Hop Frequency
Source
Internal
The Source is Internal
External
The Source is External. Use the [EXT
Trig/FSK/Burst] connector in the Rear
panel.