User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-74
DNS Setup
Press Utility I/O Setup LAN DNS Setup , to enter the following
interface.
Figure 2-85 Table 2-43 The Menu Explanations of DNS Setup
Host Name
Set the Host Name, consists of letter, number and dash (“－”). Consult to your
network administrator for information if you need to provide the Host name and the
name to use. Use the knob and direction button to select the character (you can only
use the keypad to enter number). The Host name will be stored to the Non-Volatile
Memory.
Domain Name
Set the Domain Name with letter, number, dash (-) and dot (.).Consult to your
network administrator for information if you need to provide the Domain name and
the name to use. Use the knob and direction button to select the character (you can
only use the keypad to enter number). The Domain name will be stored to the
Non-Volatile Memory.
Function
Menu
Settings
Explanation
Host
Name
Set the Host Name
Domain
Name
Set the Domain
DNS
Server
Set the Server Address
Instruction
If the DHCP is enabled, and you want to use the DNS address DHCP Server
returns, please set the Server to be “0.0.0.0”.