User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-77
To Set the System
Press Utility System , to enter the following interface.
Figure 2-88 Table 2-44 The Menu Explanations of System Setup (Page 1/2)
Figure 2-89 Table 2-45 The Menu Explanations of System Setup (Page 2/2)
Function
Menu
Settings
Explanation
Number
format
Set the number format
Language
Set the Display Language
Power On
Default
Last
all the settings return to default when
powered
all the settings return to the last one
when powered
Set to
Default
Set all the settings to default
Function
Menu
Settings
Explanation
Display
Control
Set the parameter for the Screen
Display
Beep
On
Off
Open Beep
Close Beep
Scrn Svr
On
Activate the Screen Guard Program.
Screen Guard will be on if no action is
taken within 3 minutes. Press any
button the resume.
Off
deactivate the Screen Guard Program
CLK
Source
Internal
External
Choose the systerm clock source