User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-83
3. To Return to Default Setting
Press Utility System Setup Set to Default , to set the system to the
default one. The default settings of the system are as follows:
Table 2-47 The Factory Default Setting
Modulation
Default
Carrier
1kHz Sine Wave
Modulating
100Hz Sine Wave
AM Depth
100％
FM Deviation
100Hz
FSK Hop Frequency
10Hz
FSK Frequency
100Hz
Sweep
Default
Start/Stop Frequency
100Hz/1kHz
Time
1s
Mode
Linear
Burst
Default
Frequency
1kHz
Count
1Cycle
Period
10ms
Phase
0
°
Output
Default
Function
Sine Wave
Frequency
1kHz
Amplitude/Offset
5 Vpp/ 0 Vdc
Terminals
High Z