User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-84
System
Default
*power off calling
*Disabled
Display
On
Error Array
Clear Error
Storage State and any
Waveform
No change
Trigger
Default
Source
Internal
Remote I/O Configuration
Default
*GPIB Address
*1
*I/O
*GPIB（IEEE－488）
*Baud Rate
*9600 Baud
*Parity
*No (8 bits)
*Signal Exchange
*DTR
The parameter with an asterisk（*）is stored in the Non-
Volatile Memory.