User Manual

RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
3-7
Example 4: To Generate a Pulse Wave
How to generate a Pulse waveform with 5kHz Frequency, 50mV High Level, -5mV
Low Level, 20μs Pulse Width and 10ns Edge Time.
Steps:
1. Set the Frequency.
(1) Press Pulse  Freq and choose Freq , which will display in reverse color.
(2) Input “5” from the keypad and choose the unit “kHz” to set the Frequency to
be 5kHz.
2. Set the Amplitude.
(1) Press Ampl and choose the Ampl selection which will display in
reverse color.
(2) Enter “50” from the keypad and choose the unit “mV” to set the High Level
to be 50mV.
3. Set the Offset.
(1) Press Offset to choose the Offset selection which will display in
reverse color.
(2) Enter “-5” from the keypad and choose the unit “mV” to set the Low Level to
be -5mV.
4. Set the Pulse Width.
(1) Press Pulse Width and choose Pulse Width which will display in reverse
color.
(2) Enter “20” from the keypad and choose the unit “μs” to set the Pulse Width
to be 20μs.
5. Set the Edge Time.
(1) Press Edge Time and choose Edge Time which will display in reverse
color.
(2) Enter “10” from the keypad and choose the unit “ns” to set the Edge Time to
be 10ns.
When the Frequency, Amplitude, Offset, Pulse Width and Edge Time are set, the
waveform generated is shown in figure 3-4.