User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
3-9
Example 5: To Generate a Noise Wave
How to generate a Noise waveform with 30mVpp Amplitude and 10mVdc Offset.
Steps:
1. Set the Amplitude.
(1) Press Noise Ampl and choose the Ampl selection which will display
in reverse color.
(2) Enter “30” from the keypad and choose the unit “mVpp” to set the Amplitude
to be 30mVpp.
2. Set the Offset.
(1) Press Offset to choose the Offset selection which will display in
reverse color.
(2) Enter “10” from the keypad and choose the unit “mVdc” to set the Offset to
be 10mVdc.
When the Amplitude and Offset are set, the waveform generated is shown in figure
3-5.
Figure 3-5 The Noise Waveform