User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
1-4
The Front/Rear Panel
When you get a new DG3000 Series Function/ Arbitrary Waveform Generator, first
you need to clear how to operate the front/ Rear panel correctly. This chapter will
make a brief introduction and description for the operation and functions of the
Front/ Rear Panel.
The DG3000 Series Function/ Arbitrary Waveform Generator has clear and simple
front panel. See figure 1-3 and 1-4. The Front Panel has a knob and functional keys.
The 5 blue grey buttons on the right side of the screen are menu buttons (named F1
to F5 from up to down) with the help of which, you can enter different functions
menu or have direct specific applications. The signal input and output interfaces are
set at the rear panel which can help generating multiple arbitrary waveforms. The
various BUS interfaces can meet the need of the multiple interface communications.
Figure 1-3 The Front Panel of DG3000 Series