User Manual

RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
3-22
Example 12: To Generate a Burst Waveform
How to generate a Burst Waveform of 3 Cycles. The period is 10ms. You can not
change other parameters in the default setting: Internal Source and 0 degree Phase.
Steps:
1. Choose the Burst Function:
Press Square, and choose the Square Waveform as the Burst Function.
The default setting of the Source is Internal.
2. Set the Frequency, Amplitude and Offset.
(1) Press Freq and choose Freq which will display in reverse color. Input
“5” from the keypad and choose the unit “kHz” to set the Frequency 5kHz.
(2) Press Ampl and choose Ampl which will display in reverse color. Input
“5” from the keypad and choose the unit “Vpp” to set the Amplitude 5Vpp.
(3) Press Offset and choose Offset which will display in reverse color. Input
“0” from the keypad and choose the unit “Vdc” to set the Offset 0Vdc.
You can view the Sweep Waveform parameters in the Graph Mode
3. Set the Sweep Mode.
Press Burst  N Cycle , choose N Cycle Mode. Please note that the
message shown on the top left side of the screen is “Type N Cycle”.
4. Set the Burst Period
Press Burst Period , use the keypad to enter “10”, choose the unit “ms” and set
the Period 10 ms (Please note the icon).
5. Set the Start Phase
Press Start Phase , use the keypad to enter “0”, choose the unit “°”, setting the
Start phase 0°.
6. Set the Burst Cycles
Press Burst Cycles , use the keypad to enter “3”, choose the unit “Cy”, setting
the Burst Cycle 3.
7. Set the Delay
Press Delay , use the keypad to enter “200”, choose the unit “μs”, setting the
Burst Delay 200μs.