User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
4-2
All settings are restored to factory defaults:
When all the settings of the instrument have been reset to default state, this
message will prompt to inform the user.
Storing waveform, please wait...
Inform the user that the saving operation is in process.
Performing Self-Test, Please wait...
When the Self-Test is performed, this message will prompt to inform the user to wait,
since it takes time.
Self-Test Passed.
When the Self-Test is finished, the result will be reported to the user. If the Self-test
has been passed, this message will prompt.
The Code is right. The Secure is closed. The instrument now is
UNSECURED.
Inform the user that the password is correct and the user can calibrate the
instrument now. The instrument is unsecured.
Instrument triggered.
The manual trigger mode is activated, and the expected burst or sweep will be
generated.
Selected modulating arb is **：
Inform the user of the information about the selected modulating waveform.
Calibration Count＝**，Reversion＝******：
Inform the user of the Calibration time and the version. Before the instrument is
shipped, it has already been calibrated. When you power a new instrument, the
default calibration time is 0. The latest version can be reached at the company’s
website: www.rigol.com.
Calibrating, Please wait...
In the Calibration menu, inform the user to wait when the instrument is preparing to
calibrate.
Complete. Waveform data have been changed:
Inform the user that the file has been recalled and the waveform setting is displayed.
Complete. Arb Waveform data have been changed:
Inform the user that the file has been recalled and the arbitrary waveform setting is
displayed.
Insufficient space. Fail to Save.
If the file to be stored is too large, and the Non-Volatile Memory has no enough
space, the new file can not be stored. This is to inform the user that the storage
operation failed.
Fail to read file.
If there is no file in the place the user selects, no file can be read and this message is