User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
4-3
to inform the user that the file recall operation failed.
Please select a valid File.
If the selected place is empty when recall or delete a file, this message will appear.
No Arbitrary waveform in buffer.
If the buffer has no Arbitrary waveform and user wants to store the Arb waveform
data into the Flash or U Disk, this message will appear.
State extension".rsf"; data extension".rdf".
This is the message appear when the user enter the Store/Recall interface.
Delete the file?
Confirm the deletion operation, in case of accidental operation.
Cover the file ?
If the current place has already been used when the user wants to store the file, this
message will appear to confirm the operation. If the user continues, the old file will
be covered. Press “Yes” to continue; Press “Cancel” to select the place again.
Detect a mobile disk.
The U Disk has been successfully installed, and the system has detected the portable
device.
Mobile disk is moved.
The portable disk has been removed.
Can't Write this File to system.
This message appears when the operation of burning menu or programs into the
system from the U Disk fails.
File is too big.
If the menu or programs are too large to be burnt into the system from the U Disk,
this message appears to inform the user of the overflow.
Invalid File, Fail to update.
When using the U Disk to update the system, if the updating file is invalid, this
message will appear, telling the user that the system updating operation can not be
performed.
Updating is completed. Restart the instrument.
If the System updating operation is successful using the U disk, this message will
appear. The instrument has to be reactivated to update the settings. It is also to
inform the user that if a technical problem occurs after the updating, contact the
RIGOL technician for support.
Invalid code.
When the user is updating the system, if the password is wrong, this message will
appear.
Valid code. System update is permitted
When the user is updating the system, if the password is correct this message will