User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
4-5
Error Message
Incorrect secure code, please try again.
User has to enter the correct password before they can calibrate the instrument. If
the password entered is incorrect, this message will appear to inform the user to
reenter the password.
Please first complete step**:
Before the instrument is calibrated, if the user wants to perform the selected
calibration procedure, this is to inform the user to start from step**.
Trigger ignored.
If groups of GET commands or * Trigger is received, the system will ignore the
grouped GET commands to secure the right source.
Instrument is in remote mode. Press Local.
If the instrument is in the Remote Mode, the front panel will be nullified. Press Local
(also Burst), to shift the instrument mode into local, so that the front panel can work.
Initial # of points upper limit=524,288.
The upper limit of the initial points is 524,288. If the specified waveform has more
than 524,288points, the system will adjust the number to 524,288 automatically.