User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
4-7
frequency to 30MHz automatically.
Frequency is set maximum for ramp.
The maximum frequency for Ramp is 1MHz. when the waveform is turned from one
that allows higher frequency to the Ramp waveform, the system will adjust the
frequency to 1MHz automatically.
Frequency is set maximum for Burst.
For an internal burst, the minimum frequency is 2 mHz, and the maximum is 25MHz.
Generator will adjust the frequency to be compatible to the currently specified one
automatically.
Frequency is set minimum for Burst.
For an internal burst, the minimum frequency is 2mHz, and the maximum is 25MHz.
Generator will adjust the frequency to be compatible to the currently specified one
automatically.
Frequency is set minimum for FM.
When FM is activated, the minimum carrier frequency output is 5Hz. Generator will
adjust the frequency to be compatible to the currently specified one automatically.
Sorry, unable to modulate Pulses.
Noise, Pulse and DC can not be modulated using AM, FM, PM, FSK or PWM methods.
Sorry, unable to modulate Noise.
Noise, Pulse and DC can not be modulated using AM, FM, PM, FSK or PWM methods.
Sorry, unable to modulate DC.
Noise, Pulse and DC can not be modulated using AM, FM, PM, FSK or PWM methods.
Sorry, unable to sweep Pulses.
Pulse, Noise and DC can not be used to generate sweep signals.
Sorry, unable to sweep Noise.
Pulse, Noise and DC can not be used to generate sweep signals.
Sorry, unable to sweep DC.
Pulse, Noise and DC can not be used to generate sweep signals.
Modulation has been turned off to allow Pulse.
Pulse, nose and DC are not allowed to generate modulated waveform. So the
modulation has to be turned off to allow Pulse.
Modulation has been turned off to allow Noise.
Pulse, nose and DC are not allowed to generate modulated waveform. So the
modulation has to be turned off to allow Noise
Modulation has been turned off to allow DC.
Pulse, nose and DC are not allowed to generate modulated waveform. So the
modulation has to be turned off to allow DC
Sweep has been turned off to allow Pulse.
Pulse, nose and DC are not allowed to generate Sweep waveform. So the modulation