User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
4-9
50%.
For a frequency less than 25 MHz, the Duty Cycle range is 20% to 80%.
For a frequency between 25MHz and 50MHz, the Duty Cycle range is 40% to 60%;
For a frequency greater than 50 MHz, the Duty Cycle is 50%.
Other parameters were modified.
For the Pulse Waveform, the generator will adjust the following parameters
automatically in the order below to generate the pulse waveform: Edge time- Pulse
Width-Period. When the period changes, the Edge Time and Pulse Width will also
change according to the period.
Burst type has been changed to N-Cycle.
When the Trigger Source is turn from External/ Manual to Internal, the Burst Mode
should be changed to N-Cycle.
Sorry, unable to burst DC.
Generator can not use DC Voltage function to generate Burst.
Burst has been turned off to allow DC.
Generator can not use DC to generate Burst. So the Burst is turned off.