User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
4-16
Phase Deviation Lower Limit is 0
o
. If the specified Phase Deviation is less than 0
o
, the
system will adjust the Phase Deviation to 0
o
automatically.
Phase Lower Limit = 0
o
The Phase Lower limit is 0.0
o
. If the specified Phase is less than 360.0
o
, the system
will adjust the Phase to 0.0
o
automatically.
Load Impedance upper limit =10kΩ
The Load Impedance upper limit is 10kΩ. If the specified Load Impedance is greater
than 10kΩ, the system will adjust the Load Impedance to 10kΩautomatically.
Load Impedance lower limit = 1Ω
The Load Impedance lower limit is 1Ω. If the specified Load Impedance is less than
1Ω, the system will adjust the Load Impedance to 1Ωautomatically.
(**denotes the parameter, the content of which will vary according to the
setting.)