User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
5-5
Source
Internal/ External
Modulating Waveforms
50% duty cycle square (2mHz to 100kHz)
PWM Modulation
Carrier Waveforms
Pulse
Source
Internal/ External
Modulating Waveforms
Sine, Square, Ramp, Noise, Arb (2mHz to 20kHz)
Deviation
Pulse width 0% to 100%
Sweep
Carrier Waveforms
Sine, Square, Ramp, Arb
Type
Linear or Logarithmic
Direction
Up or Down
Sweep Time
1 ms to 500 s ± 0.1%
Source
Internal/External/Manual
Burst
Waveforms
Sine, Square, Ramp, Pulse, Noise, Arb
Types
count（1 to 1,000,000 periods）, infinite, gated
Start Phase
-360° to +360°
Internal Period
1 s – 300 s ± 1%
Gate Source
External Trigger
Trigger Source
Internal/External/Manual
Rear Panel Connector
External AM
Modulation
± 5 Vpk = 100% modulation
5k input impedance
Input/Output
Frequency Range
10MHz± 500Hz
Input/Output Voltage
Range
80mVpp~10Vpp/0dBm (typical)
Lock Time
< 1s
External Trigger
TTL-compatible
Trigger Input
Input Level
TTL-compatible
Slope
Rising or falling (selectable)
Pulse Width
> 100 ns
Input Impedance
> 10 k, DC coupled
Linear Sweep
< 500 µs (typical)