User Manual

RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
5-6
Latency Sweep
< 500 ns (typical)
Trigger Output
Level
TTL-compatible into >1k
Pulse Width
> 400ns (typical)
Output Impedance
50 (typical)
Maximum Frequency
1 MHz
[Note 1]:
 DG3000 can edit the points of arbitrary wave up to 524,288, but by PC up to 1 M
(1024k), and downloaded to the volatile memory of equipment for output.
[Note 2]:
 The setting range of the amplitude (50):
If the output frequency ≤10MHz, then the amplitude range: 10mVpp~10Vpp
If the output frequency ≤80MHz, then the amplitude range: 10mVpp~5Vpp
If the output frequency >80MHz, then the amplitude range: 10mVpp~2.5Vpp
 The setting range of the amplitude (High Z):
If the output frequency ≤10MHz, then the amplitude range: 20mVpp~20Vpp
If the output frequency ≤80MHz, then the amplitude range: 20mVpp~10Vpp
If the output frequency >80MHz, then the amplitude range: 20mVpp~5Vpp
 If the output frequency >80MHz and the amplitude range: 2Vpp~5Vpp (High Z),
the amplitude flatness is 3dB.
 Square
If frequency< 8MHz, the upper limit of amplitude is 20Vpp;
If frquency ≥ 8MHz, the upper limit of amplitude is 10Vpp;
 Pulse
If frequency < 5MHz, the upper limit of amplitude is 20Vpp;
If frquency ≥ 5MHz, the upper limit of amplitude is 10Vpp;
[Note 3]:
 The values are different for different types, the type of 60MHz is 30MHz, and the
type of 100MHz is 50MHz.