User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
6-1
Chapter 6 Appendix
Appendix A: DG3000 Series Accessories
Standard Accessories:
A Power Cord that fits the standard of the destination country.
An USB Data Wire
A Set of Ultrawave Arbitrary Waveform Edition Software for WIN98/2000/XP.
An User’s Guide
Optional Accessories:
A BNC Cable
A RS-232 Cable
Logic Signal Output Module (DG-POD-A)
Logic Cable
NOTE:
To avoid affecting the product performance, the length of USB data wire
connected to the instrument should be less than 3m.
All the accessories (standard and optional) are available by contacting your local
RIGOL office.