User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
1-8
To Set a Waveform
On the operation panel, there is a set of buttons with waveform icon. See figure 1-7.
The exercise below will help you familiarize with the waveform selection settings.
Figure 1-7 The Waveform Selection Buttons
1. Press Sine button and the waveform window will display sine waveform.
DG3000 Series Generator can generate Sine signal with a frequency from 1μHz
to 120MHz. By setting Frequency/Period, Amplitude/High Level, Offset/Low level,
sine signal with different parameters can be generated.
Figure 1-8 The Sine Signal Display Interface