User Manual

RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
1-14
To Set Trigger/Output
As shown in figure 1-18, there are two buttons on the right side of the operation
panel, which are used to set Trigger and Output Control. The instruction below will
help you familiarize with these functions.
Figure 1-18
The Trigger/ Output Button
1. Press Trigger Button, choose internal/ external or manual Trigger (Manual
Trigger can only be used in Sweep and N-Cycle Burst)
 The default setting for Trigger is “Internal”. In this mode, when the Sweep
or Burst Mode is also selected, the Generator will generate burst
continuously. At this time, press Trigger button, the instrument will shift
from the “Automatic” Trigger mode into “Manual” Trigger mode.
 When the generator uses the” External” Trigger Mode, if the Sweep or the
Burst Mode is selected, signal will be generated continuously. At this time,
press Trigger button, the instrument state will not change, and it will show
“The instrument has already been triggered”.
 Every time you press the Trigger button, “Manual” Trigger will start a
sweep or generate a burst. Press the button again, and the generator will
be triggered again.
2. Press Output Button, activate or deactivate the output signal.
If an overload message is shown, disconnect the external equipment from the
output terminals and press Output button, reactivate the output terminal.