User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
1-16
To Use Store/Utility/Help Function
As shown in figure 1-20, there are three buttons on the operation panel, which are
used to call the store/recall, utility and help function. The instruction below will help
you familiarize with these Functions.
Figure 1-20
The Store/Recall, Utility and Help Button
1. The Store/Recall Button is used to store waveform data and configure
information.
2. The Utility Button is used to set the auxiliary system function, change the output
configure parameters, interface setting, system setting information or perform
the instrument self-test and read the calibration information, etc.
3. The Help Button is used to read the help information.
Operation Instruction
To get help on:
To get help on any key of the front panel, press and hold on that key for 1 second
and the help message will appear.