User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-2
To Set Sine Signals
Press Sine Button to call the Sine operation. The Sine waveform parameters are set
by using the Sine operation menu.
The parameters of Sine waveforms are: Frequency/ Period, Amplitude/ High Level,
Offset/ Low Level. Different Sine Signals are generated by setting these parameters.
The parameter value in the waveform display window is the same as that of in the
parameter display window. As is shown in figure 2-1, in the soft key menu, select
Freq. Cursor is located in the frequency parameter area in the parameter display
window, and users can set the frequency value here. In the waveform display window,
the parameter type in the left corner is frequency, the value of which is displayed in
shadow.
Figure 2-1 The Sine Parameter Display Interface
Operation
Menu:
Control
function
with the
soft keys
Amplitude
Offset
Frequency
Waveform
Waveform
Display Window
Frequency
Value
Current
Parameter