User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-5
To Set the Output Amplitude
1. Press Sine Ampl , to set the amplitude.
The amplitude shown on the screen when the instrument is powered is the
default value or the set value beforehand. When changing the function, if the
current value is valid for the new waveform, it will be used sequentially. If you
want to set the waveform by high Level or Low Level, press the Ampl/High
Level or Offset/Low level button again, to switch into the High Level or
Low Level parameter (The current operation is displayed in inverse color).
2. Input the desired Amplitude
Use the keypad or the knob to input the desired value, choose the unit, and press
the corresponding button.
Figure 2-4 Setting the Amplitude
Current
Parameter:
Amplitude