User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-7
To Set Square Signals
Press Square button to call the Square operation. The Square waveform parameters
are set by using the Square operation menu.
The parameters of Square waveforms are: Frequency/ Period, Amplitude/ High Level,
Offset/ Low Level and Duty Cycle. See figure 2-6. The parameter value in the
waveform display window is the same as that of in the parameter display window and
the Duty Cycle value is edited directly in the waveform display window. In the soft key
menu, select Duty Cycle, and the corresponding value in the waveform display
window will be displayed in shadow, and then users can edit its value.
Figure 2-6 The Square Parameter Display Interface
Duty Cycle