User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-22
1. To Select the Built-in Waveform
Press Arb Sel Wform Built-In , and enter the following interface.
Figure 2-22 Table 2-8 The Menu Explanations of Built-in Arbitrary Waveform
(Page 1/2)
Figure 2-23 Table 2-9 The Menu Explanations of Built-in Arbitrary Waveform
(Page 2/2)
Function
Menu
Settings
Explanation
ExpRise
Select the built-in Exponential Rise
Waveform
ExpFall
Select the built-in Exponential Fall
Waveform
NegRamp
Select the built-in Negative Ramp
Waveform
Sinc
Select the built-in Sinc Waveform.
Sinc=Sin(x)/x
1/2
Enter next page ( the followings are
the same)
Function
Menu
Settings
Explanation
2/2
Return previous page (the followings
are the same)
Cardiac
Select the built-in Cardiac Waveform