User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-23
2. To Select the Stored Waveform
Press Arb Sel Wform Stored Wform , and enter the following
interface.
Figure 2-24 Table 2-10 The Menu Explanations of Stored Arbitrary Waveform
(Page 1/2)
Figure 2-25 Table 2-11 The Menu Explanations of Stored Arbitrary Waveform
(Page 2/2)
Function
Menu
Settings
Explanation
ARB Mem1
Select the Arb Waveform stored in the
non-Volatile Memory. The location is:
C:\ARB1:ARB_1
ARB Mem 2
Select the Arb Waveform stored in the
non-Volatile Memory. The location is:
C:\ARB2:ARB_2
ARB Mem 3
Select the Arb Waveform stored in the
non-Volatile Memory. The location is:
C:\ARB3:ARB_3
ARB Mem 4
Select the Arb Waveform stored in the
non-Volatile Memory. The location is:
C:\ARB4:ARB_4
Function
Menu
Settings
Explanation
Select Arb
Open the selected waveform
Instructions:
When there is no waveform stored in the Arb Mem1 、 Arb Mem2 、 Arb Mem3
and Arb Mem4, this menu will hide. (The followings are the same and will not be
explained )