User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-26
1. To Create a New Waveform
Press Arb EditWform Create New ,to set the overall parameter for
the waveform. Interface is shown in figure 2-29 and menu in table 2-15.
Figure 2-29
The Setting Interface of New Waveform Parameter
Figure 2-30 Table 2-15 The Menu Explanations of the New Waveform Parameters
(Page 1/2)
Function
Menu
Settings
Explanation
Cycle
Period
Setting the Cycle Period for the
Waveform
HighV Limi
Setting the Level High Limit for
the Waveform
LowV Limit
Setting the Level Low Limit for
the Waveform
Int# Points
Set the number of initial points
when Initializing the waveform
Period
Initial Points Number
Interpolation On
High Level
Low Level