User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-31
2. To Edit the Stored Waveform
Press Arb Edit Wform Edit Stored , to enter the following interface.
Figure 2-36 Table 2-20 The Menu Explanations of Editing Stored Waveform
(Page 1/2)
Figure 2-37 Table 2-21 The Menu Explanations of Editing Stored Waveform
(Page 2/2)
3. To Delete a Waveform
Press Arb Edit Wform DELETE Wform , to delete a waveform.
Function
Menu
Settings
Explanation
ARB
Mem1
Select the Arb Waveform stored in the
non-Volatile Memory. The default
location is: C:\ARB1:ARB_1
ARB Mem
2
Select the Arb Waveform stored in the
non-Volatile Memory. The default
location is: C:\ARB2:ARB_2
ARB Mem
3
Select the Arb Waveform stored in the
non-Volatile Memory. The default
location is: C:\ARB3:ARB_3
ARB Mem
4
Select the Arb Waveform stored in the
non-Volatile Memory. The default
location is: C:\ARB4:ARB_4
Function
Menu
Settings
Explanation
Edit Arb
Edit the selected waveform