User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-42
To Generate Sweep
In the frequency sweep mode, the function generator “steps” from the start
frequency to the stop frequency at the sweep rate you specify. Sweep can be
generated by Sine, Square, Ramp or Arbitrary Waveforms (Pulse, Noise and DC are
not allowed).
Figure 2-48
The Setting Interface of Sweep Waveform Parameter
Press Sweep button to enter the following menu. Set the Waveform parameters by
using the operation menu.
Start Frequency
Stop Frequency
Sweep Time
Sweep Type
Source
Trigger