User Manual
Table Of Contents
- Safety Notices
- The Introduction of DG3000 Series
- Getting Started
- Operating Your Generator
- Application & Examples
- Example 1: To Generate a Sine Wave
- Example 2: To Generate a Square Wave
- Example 3: To Generate a Ramp Wave
- Example 4: To Generate a Pulse Wave
- Example 5: To Generate a Noise Wave
- Example 6: To Generate an Arbitrary Waveform
- Example 7: To Create an Arbitrary Waveform
- Example 8: To Generate an AM Waveform
- Example 9: To Generate an FSK Waveform
- Example 10: To Generate a PWM waveform
- Example 11: To Generate Linear Sweep
- Example 12: To Generate a Burst Waveform
- Prompt messages & troubleshooting
- Specifications
- Appendix
- Index
RIGOL
© 2006 RIGOL Technologies, Inc.
User’s Guide for DG3000 Series
2-48
To Store and Recall
Press Store/Recall Button to enter the following interface. You can save or recall the
State or Data Documentation inside the Generator. The status file and data file on the
U Disk are also allowed to rebuild or delete. File names can either be Chinese or
English.
Figure 2-55 The Save and Read Interface
Figure 2-56 Table 2-32 The Menu Explanations of Save and Recall (Page 1/2)
Function
Menu
Settings
Explanation
File Type
State
Data
All File
The Setting of the Generator
Arbitrary Waveform file
All kinds of files
Browser
Path
Directory
File
Shift between the Path,
Directory and file
Save
Save the waveform to the
appointed place
Recall
Recall the waveform or
Setting information in the
specific position in the
memory.